• ru

  • defeating gravity

    • cederic duss f3k eurotour champion

      Congratulations to Cederic Duss (SUI) – winner of F3K World Cup and CONTEST Eurotour 2017

    • joe wurts plus f5j new2
    • dominik prestele f3j eurotour champion

      Congratulations to Dominik Prestele (GER) - F3J CONTEST Eurotour winner 2017

    • shinto col de tende fai eurotour

         Congratulations to Sebastien Lanes (Shinto) - winner of the Col de Tende FAI eurotour and Pierre Rondel (Shinto) with 3rd place!

    • nikita sholom junior world champion 2016

      Congratulations to Nikita Sholom (UKR) - the new F3J Junior World Champion 2016.

    items
    0
    0
    add to cart

    Batteries

    Top

    SmartLipo battery is a highly integrated device for powering your RC model. Thanks to integrated booster, switching charge circuit and battery condition monitor unit now you can stop to use many external devices for your model receiver batteries operation!SmartLipo have single two-pin port used for connecting to charge power supply(revese polarity protected), and for turing ON/OFF.

    To Power ON your SmartLipo remove jumper from “ON/OFF” port. If the SmartLipo is charged you will hear 0-7 beeps*(means 3.5-4.2V on cell). For SmartLipo v2 and newer you also will have red led turned on. 6-7 beeps* – completely charged SmartLipo. If you here 0 beeps* – you need to charge your SmartLipo before use.

    While SmartLipo is turned ON it makes regular beeps to show this state(to prevent model packing with powered receiver). If the cell voltage drops lower than 3.5V internal voltage - this beep will be changed to trills(”Ti-ta-Ti”). If the cell voltage drops lower than 2.9V for 3 seconds SmartLipo will be turned OFF automaticaly. Time of cell discharging between 3.5V and 2.9V depends on your model total power consumtion, typicaly it is about 1-2 minutes but this value may be lower. We recommend to charge SmartLipo between flights and check the voltage on the cell using jumper place/remove cycle time to time. We do not recommend to fly till trills or full discharge. If you remove jumper and hear only 1 beep - stop flying and charge your SmartLipo.

    To Power OFF - place jumper to the “ON/OFF” port.

    To Charge your SmartLipo apply 5-15V power source to Charge In port in appropriated polarity. Power source need to be capable to handle at least doubled charge current(for 240mah – 0.5A).Ideal power source is another battery (e.g Car battery) or any other stabilized power supply. While charging you will hear short “tick” sounds, as soon as charging will be done, you will hear “beeps” instead. When the cell is completely charged SmartLipo will be switched into trickle charge mode. Internal condition monitor will prevent battery overcharging.Typical full charge time is about 1.5hours. We do not recommend to use exactly 5V power source for charging because possible voltage drops.


    You can download a PDF file with brief instructions on using RC Smart LiPo

    pdflogo Instruction on using SmartLipo